Brake; General - DEMAG DRF 200 Assembly Instructions Manual

8.4.3

Brake

8.4.3.1

General

DANGER
Inappropriate maintenance work
Danger to life and limb. Risk of material damage.
Check brake air gap s
If the brake is not adjusted, it will no longer release after further wear. If the motor then operates against the
applied brake, the brake and motor may be damaged.
Apart from wear, the brake is virtually maintenance-free.
The organic/mineral brake lining is designed in such a way that worn surface particles are only given off as mini‐
mal abrasion. This built-in regeneration of the brake lining surface ensures that the braking characteristics remain
constant. To ensure the brake releases reliably, air gap s
Brake air gap s
The brake disc can be freely turned when the brake is released (power applied to brake coil).
Brake size
Remaining thickness b
min
Adjusting angle α
1
Tab. 27
When the brake has been adjusted several times, the remaining thickness b
The guide pins feature an easily visible mark (x) which clearly indicates the minimum dimension. The brake rotor
must be replaced when this mark is exceeded. A maintenance and spare parts set is available to do this.
The air gap must be adjusted when the max. permissible value s
brake no longer releases).
For DRF units fitted with KBF motors, see "KBA, KBF motor assembly instructions"  Tab. 2, Page 2.
at certain intervals and adjust it, as required.
1
= 0,35 mm - s = 1,2 mm
1min 1max
must be regularly checked and adjusted, as required.
1
B004
5
120°
has been reached, (however, immediately if the
1
B020
6
120°
of the brake disc must be checked.
min
41