Panasonic AV-SF500 Operating Instructions Manual page 33

Live Switcher
Next, set the user name. Click the User Name section to display the below entry screen.
Enter the user name set with the AV-UHS500 main unit to authenticate the software panel.
Next, set the password. Click the Password section to display the below entry screen.
Enter the password set with the AV-UHS500 main unit to authenticate the software panel.
Then, click the Connect button found at the bottom right of A section.
2) Automatic setup: Clicking the Search button automatically searches and displays the IP address
of the AV-UHS500 on the same network as the PC running the Software Control Panel. Click the
IP address of the desired AV-UHS500 from the search results, and click the Connect button. All
of the AV-UHS500 on the local network that does not pass via the network router are searched.
The AV-UHS500 of the different subnet is also displayed, however, connection is not possible
even by pressing the Connect button. If the subnet is different, change it so that the IP address
and subnet mask of the PC matches the subnet of the AV-UHS500.
If it connects normally, the "Currently connected IP address" appears in the Connect IP Address
area.
B Version display area
It displays the firmware version of the connected AV-UHS500 and the software version of the
Software Control Panel.
Switcher System version: Firmware version of the AV-UHS500's main unit.
Software Panel version: Software version of the Software Control Panel
C Time synchronizing area
Time information for the PC installed with this software is transmitted to the main unit of the
AV-UHS500 enabling times to be synchronized. Press the DateTimeSet button to synchronize the
times.
© Panasonic Corporation 2022
Software Control Panel
- 33 -