Table of Contents
Advertisement
MLA MINI
USER GUIDE
Step 6: Lift the next cabinet on top of the previous one and secure both the front corners with
further Flying Pins. At the rear, rotate the upper cabinet's flip-down bracket so that it engages
with the slot in the lower cabinet, and set the angle between the first and second cabinets to
10° by fitting a Flying Pin in the hole marked "10" on the lower bracket. This gives the correct
inter-cabinet angle required by Preset 4.
Step 7: Repeat Step 6 twice to add the two remaining MLA Mini cabinets, while referring to the
Preset diagrams on page 20 and the table below. Take care to set the correct angles.
Step 8: The connections to the 4 x Mini array (see page 22) are most conveniently made at
this stage.
Summary of angles (Preset 4):
Bracket tilt angle
Inter-cabinet
angles between:
36
Preset 4
20°
Cabinets 1 & 2
10°
Cabinets 2 & 3
6.5°
Cabinets 3 & 4
0.5°
MLA Mini User Guide V1.0
Advertisement
Table of Contents
