Loading binary presets into your Martin Audio DX2
Loudspeaker Management System
here takes you to a zip folder
Extract these to your hard disk. Do not run the programme from the zip folder.
Loading presets will overwrite previously loaded factory presets - and any
changes to them (e.g. channel gain, delay, limiter settings).
To make a permanent record of changes to the user-editable parts of a preset,
you must save the preset in one of the lower number memory locations.
Make sure you have a full set of .bin files before proceeding so that you can
reload your original presets if you need to.
If you are not familiar with the Martin Audio DX2, please read the DX2
You should have extracted the following files to a suitable folder on your
MartinFlashLoader.exe – The DX2 binary preset loader software
MARTN1RLCDLC21801.bin – Binary presets for
MARTN1RLCDLCWLX01.bin – Binary presets for W8LCD+W8LC+WLX
MARTN1RLDLBLS02.bin – Binary presets for W8LD+W8L
MARTN1RLM218X03.bin – Binary presets for
MARTN1RLMWLX03.bin – Binary presets for W8LMD/LM+WLX
MARTN1RLMWMX03.bin – Binary presets for W8LMD/LM+WMX
MARTN1RLE12152101.bin – Binary presets for 4-mix LE1200, LE1500
or LE2100 systems
All material © 2007. Martin Audio Ltd. Subject to change without notice.
containing the loader software and binary files.