Table of Contents
Advertisement
MLA MINI
USER GUIDE
Ground Stack Baseplate
This is normally fitted to the base of the MSX for configurations where the MSX is attached to the
4 x Mini array (either directly or with the Variable Height Pole Mount) to give greater stability. It
can also be used with the 4 x Mini array alone, with the Flying Frame as an intermediate adaptor.
The Ground Stack Baseplate is often referred to as an "Outrigger" or "Duck's Foot".
Ground Stack Bars
These precision alignment bars are used in conjunction with the Flying Frame to define the angle
between the 4 x Mini array and the MSX sub when the system is configured for ground stacking.
They will also be needed when the 4 x Mini array is to be ground stacked alone. Two versions are
available, long and short; the two sizes allow different ranges of angles to be set.
Flying Pins
The pins are used to lock the individual Mini cabinets into position at the defined inter-cabinet
angle, and also to lock the 4 x Mini array to the Transition Frame or Flying Frame at the required
angle. The pins are supplied with the relevant components.
MLA Mini User Guide V1.0
14
Advertisement
Table of Contents
