XTline XT106400 User Manual page 57

Straigth guide when using
as a router (needed to use
with guide holder).
Install the straight guide on
the guide holder (optional
accessory) with the wing
nut. Insert the guide holder
into the holes in the plunge
base and tighten the wing
bolts. To adjust the distance
between the bit and straight
guide, loosen the wing nut.
At the desired distance,
tighten the winbg nut to
secure the straight guide in
place.
To install the straight guide, insert the guide bars into
the holes in the plunge base. Adjust the distance
between the bit and the straight guide. At the
desired~distance, tighten the wing bolts to secure the
straight guide in place. When cutting move the tool
with the straight guide flush with side of the
workpiece.
If the distance (A) between the side of the workpiece
and the cutting position is too wide for straight guide,
or if the side of the workpiece is not straight, the
straight guide cannot be used. In this case, firmly
clamp a straight board to the workpiece and use it as a
guide against the router base. Feed the tool in the
direction of the arrow.
Immersion base (E)
The templet guide provides a sleeve through which
the bit passes, allowing use of the tool with templet
patterns. To install the templet guide, loosen the
screws on the tool base, insert the templet guide and
then tighten the screws.
1) Screw
2) Base
3) Templet
Straight guide
Secure the templet to the workpiece. Place the
tool on the templet and move the tool with the
templet guide along the side of the templet.
1) Bolt
2) Guide holder
3) Wing nut
4) Bolt
5) Wing nut
6) Straight guide
7) Wing bolts
The straight guide is
effectively used for
straight cuts when
chamfering or grooving.
1) Guide bar
2) Wing bolt
3) Straight guide
1) Bit
2) Base
3) Template
4) Workpiece
5) Distance (X)
6) Outside diameter of
the templet guide
7) Templet guide