XTline XT106400 User Manual page 52

Straight guide (B)
The straight guide is effectively used for straight cuts when chamfening or grooving.
Attach the guide plate to the straight guide with the bolt and the wing nut.
1. Bolt
2. Guide plate
3. Straight guide
4. Wing nut
Attach the straight guide with the clamp screw (A). Loosen the wing nut on the
straight guide and adjust the distance between the bit and the straight guide. At the
desired distance, tighten the wing nut securely.
1. Clamp screw
2. Straight guide
3. Wing nut
4. Base
When cutting, move the tool with the straight guide flush
with the side of the workpiece. If the distance (A)
between the side of the workpiece and the cutting position
is too wide for the straight guide, or if the side of the
workpiece is not straight, the straight guide cannot be
used. In this case, firmly clamp a straight board to the
workpiece and use it as a guide against the trimmer base.
Feed the tool in the direction of the arrow.
Circular work
Circular work may be accomplished if you assemble the
straight guide and guide plate as shown in the figures.
Min. and max. radius of circles to be cut (distance
between the center of circle and the center of bit) are as
follows: Min. 70mm (2-3/4"), Max. 221mm (8-11/16").
For cutting circles betweeb 70mm (2-3/4") and 121mm
(4-3/4") in radius.
For cutting circles between 121mm (4-3/4") and 221mm
(8-11/16")
i
, � · � �
\_ i;