XTline XT106400 User Manual page 56

Then mount the handle-type
handle on the base. Cutting
depth adjustment when
using the plunge base
Place the tool on a flat surface. Loosen the lock lever and lower the tool body until the bit just
touches the fasr surface. Tighten the lock lever to lock the tool body. Turn the stopper pole
setting nut counterclockwise. Lower the stopper pole until it makes contact with the adjusting
bolt. Align the depth pointer with the "0" graduation. The depth of cut is indicated on the scale
by the depth pointer. While pressing the fast-feed button, raise the stopper pole until the
desired depth of cut obtained. Minute depth adjustments can be obtained by turning the
adjusting knob (1 mm per turn). By turning the stopper pole setting nut clockwise, you can
fasten the stopper pole firmly. Now, your predetermined depth of cut can be obtained by
loosening the lock lever and then lowering the tool body until the stopper pole makes contact
with the adjusting hex bolt of the stopper block. Always firmly hold the tool by both grip
during operation. Set the tool base on the workpiece to be cut without the bit making any
contact. Then turn the tool on and wait until the bit attains full speed. Lower the tool body and
move the tool forward over the workpiece surface, keeping the tool base flush and advancing
smoothly until the cutting is complete. When doing edge cutting, the workpiece surface should
be on the left side of the bit in the feed direction.
. l- X�: : : � , - � ,�
'
Note:
• Moving the tool forward too fast may cause a poor quality of cut or damaged to the bit or
motor. Moving the tool forward too slowly may burn and may the cut. The proper feed rate
will depend on the bit size, the kind of workpiece and depth of cut. Before beginning the cut
on the actual workpiece, it is advisable to make a sample cut on a piece of scrap lumber. This
will show exactly how the cut will look as well as enable you to check dimensions. When
using the straight guide, be sure to install it on the right side in the feed direction. This will
help to keep it flush with the side of the workpiece.
�1!:;;
,, .,. , .,
.,
'
.-,
1) Feed direction
2) Bit revolving
direction
3) Workpiece
4) Straight guide
1) Adjusting knob
2) Lock lever
3) Depth pointer
4) Stopper pole
setting nut
5) Fast feed button
6) Stopper pole
7) Stopper block
8) Adjusting bolt
1) Workpiece
2) Bit revolving direction
3) Vief from the top of
the tool
4) Feed direction