Roborock S300RR User Manual page 22

Instructions for Use
On/Off
Press and hold the button to turn on the robot. The power indicator
will turn on and the robot will enter standby mode.
Press and hold the button to turn off the robot and complete the WashVac
cycle.
Note: The robot cannot be turned off when it is being charged.
WashVac (Vacuum & Wash)
1. Filling the Water Tank
Take out the clean water tank and remove the filling port cover. Add 3/4
cap (about 15 mL) of cleaning fluid specified by Roborock, and then
add water below the Max line. Tighten the port cover and fit the water
tank back in place.
Notes:
• Do not use cleaning fluid other than that specified by Roborock to avoid corrosion of the
robot or the dock.
• Do not add too much cleaning fluid to prevent the robot from working improperly due to slipping.
• Do not use hot water as this may cause the tank to deform.
• If any water stains remain on the outside of the water tank, wipe them with a soft dry cloth
before reinstalling the tank.
2. Starting WashVac
Press the
according to its scan of the room. It splits a room into zones, first draws
out zone edges, and then fills the zone in a zigzag pattern. In so doing, the
robot cleans all zones one by one, efficiently cleaning the house. During
cleaning, the robot automatically determines when it should wash the
mop and fill the water tank to maximize its washing performance.
Notes:
• To allow the robot to wash the mop automatically, start the robot from the dock once it is
fully charged. Do not move the dock during WashVac.
• When using the robot for the first time, follow it and watch for potential problems.
• WashVac cannot start when the battery is low. Allow the robot to charge before starting
cleanup.
• Before WashVac, tidy cables (including the power cable of the dock) and valuables from the
floor. Loose items may be dragged by the robot, resulting in the disconnection of electrical
appliances or damage of cables and property.
• If WashVac is completed in less than 10 minutes, the area will be cleaned twice.
• If the battery runs low during the WashVac cycle, the robot will automatically return to the
dock. After charging, the robot will resume where it left off.
• Automatic mop washing will not work if the dock encounters an error during WashVac. Wash
the mop manually to restore.
• The robot will retract the mop bracket to clean the carpet. You can also set the carpet as a no-
About 15 mL
go zone in the app to avoid it.
22
button to start cleaning. The robot will plan its WashVac route