Oven Light Replacement - GE PT925SNSS - Profile 30" SC Convection Ovens Owner's Manual

Ge profile 30" built-in single/double convection wall oven
Hide thumbs Also See for PT925SNSS - Profile 30" SC Convection Ovens:
Table of Contents

Advertisement

Available languages

Available languages

WARNING
CAUTION
Socket
Receptacle
G6.35 Bulb
Tab
Glass cover
(on some models)
Socket
Receptacle
G9 Bulb
Tab
Glass cover
(on some models)
Wipe up heavy soil on the oven bottom.
NOTE: Do not attempt to lift the heating
element. Doing so could damage
the element.
SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect
the electrical power to the oven at the main fuse or circuit breaker panel.
Failure to do so may result in electric shock or burn.
BURN HAZARD: The glass cover and bulb should be removed when cool.
Touching hot glass with bare hands or a damp cloth can cause burns.

Oven Light Replacement

To remove:
Turn the glass cover counterclockwise
1/4 turn until the tabs of the glass
cover clear the grooves of the socket.
Wearing latex gloves may offer
a better grip.
Using gloves or a dry cloth, remove
the bulb by pulling it straight out.
To replace:
Use a new 120/130-volt halogen bulb,
not to exceed 50 watts. Replace the
bulb with the same type of bulb that
was removed. Your model will have
one of the two types shown on
the left. To determine the correct
replacement bulb, check the bulb
terminals. Bulbs with 2 straight pin
terminals are G6.35 bulbs. Bulbs
with 2 looped terminals are G9 bulbs.
(Do not interchange.) Be sure the
replacement bulb is rated 120 volts
or 130 volts (NOT 12 volts).
Using gloves or a dry cloth, remove
the bulb from its packaging. Do not
touch the bulb with bare fingers. Oil
from skin will damage the bulb and
shorten its life.
Oven Heating Elements
Do not clean the heating elements.
Any soil will burn off when the elements
are heated. Clean the oven floor with
warm, soapy water.
(on some models)
Receptacle
Push the bulb straight into the
receptacle all the way.
Place the tabs of the glass cover into
the grooves of the socket. Turn the
glass cover clockwise 1/4 turn.
For improved lighting inside the oven,
clean the glass cover frequently using
a wet cloth. This should be done when
the oven is completely cool.
Reconnect electrical power to
the oven.
GEAppliances.com
Use gloves
or cloth
27

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pt925dnbbProfile pt925dnPt925

Table of Contents