Table of Contents
Advertisement
3
3.7.4
Critical Suspend State
The Critical Suspend state occurs when the power switch is turned off (or power is
disconnected) and the backup battery is supplying power to the DL8700. Backup Battery
Power Failure can occur because the backup battery's energy has been depleted or the
backup battery has been removed.
When the unit is in the Critical Suspend state the Status LED blinks green, all peripherals are
shut down, the CPU clock is stopped, power is removed from the PCMCIA card(s) and the
DL8700 may beep. The DL8700 is saving the state prior to shut down and cannot be used.
If the power supply is re-connected before the Off Timer expires the unit transitions to the On
state.
When the Off Timer expires the unit turns itself off and all unsaved information is lost.
Connect the main power source and toggle the On/Off switch to On to turn the unit back on.
Note : The Off Timer is configured in the BIOS Setup (see the "VX1 Reference Guide." by
LXE Inc.)
3.8 LASER BARCODE SCANNER WARNINGS
•
Do not look into the laser's lens.
•
Do not stare directly into the laser beam.
•
Do not remove the laser caution labels from the scanner.
•
Do not connect the tethered laser barcode scanner to any other device.
Please read the caution labels. Avoid exposure. Laser light is emitted
from the scanner's aperture. Use of controls, adjustments or
performance of procedures other than those specified herein may result
in hazardous radiation exposure. The scanner uses laser light. The
following labels are representations of caution and warning labels
CAUTION
placed on laser scanners.
Figure 35 - Caution Labels - Class II Scanner
30
Figure 36 - Caution Labels - Class IIIA Scanner
DL8700
Advertisement
Table of Contents
