Table of Contents
Advertisement
2
For uninterrupted power, electrical supply connections should not be made
at any point after the ignition switch of the vehicle.
CAUTION
3. Route the cable the shortest way possible. The input cable from the connection to the
battery is rated for a maximum temperature of 105°C (221°F). When routing this cable it
should be protected from physical damage and from surfaces, which might exceed this
temperature.
Do not expose the cable to chemicals or oil that may cause the wiring insulation to
deteriorate.
If the vehicle is equipped with a panel containing Silicon Controller
Rectifiers (SCR's), avoid routing the power cable in close proximity to these
devices.
NOTE
Always route the cable so that it does not interfere with safe operation and maintenance of
the vehicle.
Use proper electrical and mechanical fastening means for terminating the cable. Properly
sized "crimp" type electrical terminals are an accepted method of termination. Please select
electrical connectors sized for use with 18AWG (1mm
Wiring color codes for DATALOGIC supplied DC input power cabling:
+12 - 80VDC (DC +)
Return (DC -)
Vehicle Chassis (GND)
DL8700 accepts a wide DC input voltage range. Do not connect the
DL8700 input power cable to any other computer or damage to that
computer may occur.
NOTE
4. Provide mechanical support for the cable by securing it to the vehicle structure at
approximately one foot intervals, taking care not to overtighten and pinch conductors or
penetrate outer cable jacket.
5. Connect the cable to the DL8700 by aligning the Molex connector pins to the power
connector; push down on the Molex connector and twist it to fasten securely.
6. Turn the DL8700 on.
22
VehicleSupply
2
) conductors.
Wire Color
Red with White Stripe
Red with Black Stripe
Green
DL8700
Advertisement
Table of Contents
