Dyno Driver For Windows 10 - Mini Pro Chassis Dyno V2 Instruction Manual

DRIVER INSTALLATION
Electronic Board Driver Installation for Windows 10
1
Connect the dyno to the pc using the
micro-b USB cable.
Go to -->https://support.minipro.com/095696-Drivers
and download the latest driver and extract the driver to a
new folder.
NOTE: The electrinic board driver is installed automatically by
Windows 10; however, you must update the driver..
3
To open the device manager, right-click on
the Windows Start Button, and click "Device
Manager."
2
Verify the driver was automatically installed
by opening the "Device Manager."
NOTE: When you plug the dyno, a new comunication port
should appear when the driver was installed successfully.
4
Take note of the new comunication port
created by the electronic board driver.
4.1. Right Click and select "Update Driver Software"
4.2 Select "Browse my computer... " "
4.3. Select "Let me pick from a list.. "
4.4. Select "Have a disk" and locate the driver that was
saved earlier.
NOTE: The communication port is required to run the dyno.
Above port number may differ from your pc.
CONT.
16