Table of Contents
Advertisement
3.5
Setting the Projector Projection Method
When the projector is shipped from the factory, the projection method is set to the front mode
(projection from the front of the screen with the projector installed on the pedestal).
This procedure is described for the example of using the LCD screen of the projector main unit.
Refer to the projector user's manual for details on how to use the main unit operating panel.
Press the MENU button for three seconds or longer.
[1]
The Passcode input screen appears on the LCD screen at the projector's control panel.
Press the EXIT button to return to the original screen.
Enter the passcode and press the ENTER button.
[2]
If you make a mistake during input, you can move the cursor by pressing the LEFT/RIGHT buttons
and overwrite the passcode.
If the passcode is correct, you can use the service personnel menu.
Press the LEFT/RIGHT button to display "Configuration" and press
[3]
the DOWN button.
Press the LEFT/RIGHT button to display "Installation" and press
[4]
the DOWN button.
Check that "Image Orient" is properly selected and press the
[5]
DOWN button.
If "Image Orient" is not properly selected, press the LEFT/RIGHT buttons to select it
Press the LEFT/RIGHT buttons to select the projection method
[6]
(Image Orientation).
When shipped from the factory, it is set to [Normal-F].
- Normal-F Front projection. With the projector installed on the pedestal, projection is executed
- Normal-R Rear projection. With the projector installed on the pedestal, projection is executed
Press the ENTER button.
[7]
An (*) will be put on the selected projection method (Image Orientation).
Press the EXIT button several times.
[8]
The projector exits the menu and goes back to the regular screen.
If you press the EXIT button and then select "Yes" and press the ENTER button on a regular screen,
you are returned to user mode.
112
from the front of the screen.
from the back of the screen.
3. Projector Adjustment and Connection
Advertisement
Table of Contents
