2.11 Mounting The Option Board - NEC NC3200S Installation Manual

2.11 Mounting the Option Board

The following option board or multimedia switcher (MM3000B) can be mounted to the slot A and
B of the projector.
Image Media Block
Signal Input Board
Multi-media Switcher
This section describes the procedure of mouting the media block and signal input board. For the
procedure of mouting multi-media switcher, refer to "MM3000B Installation Manual".
Preparatory operation:
Phillips head screwdriver (No.2) and cover key (attached goods).
- Step 1
Remove the Projector Cover (See page 101)
- Step 2
Mount the Option Board to the Projector (See page 101)
- Step 3
Mount the Cover to the Projector (See page 102)
- Step 4
Recovering from Tamper Errors (See page 106)
Setting up the Projector (See page 103)
Note
If you remove the front cover, side cover, or lens side cover, the following error message is
displayed on the LCD screen of the main unit operating panel by the tamper detection circuit.
"Tamper Fail", "Service Door Open"
Also, if you remove the closing panel or device from slot, the following error message is
displayed on the LCD screen of the main unit operating panel by the tamper detection circuit.
Furthermore, since the marriage is cleared, re-marriage is necessary.
"Marriage Tamper Fail", "Physical Marriage Tamper", "Marriage Not Active"
Encrypted contents cannot be displayed while an error message is being displayed. Refer to
"3.2 Recovering from Tamper Errors" (page 106) for the recovery procedure.
100
Name
NC-80MB01
NC-80LB01
NC-80DS01
MM3000B
Slot A Slot B
* *
* *
* *
* -
2. Setting Up Your Projector