Table of Contents
Advertisement
Checking Connections and Finishing Up
Finishing Up
Before you finalize the installation, double-check these connections:
Make sure that all wires are neatly routed and secured.
1.
Be sure to provide adequate strain relief for wires going to the
2.
terminal blocks.
Check to see whether voltage and current wires are paired
3.
correctly. If they are not, you can make changes through the Power
Analysis System Software or through Scenario.
Confirm that the range lights (LEDs) are correct.
4.
Make sure the installation meets all applicable safety codes.
5.
Re-install all panel covers as required.
6.
What Next?
See the Power Recorder System User Guide or the Scenario User Guide for
information about how to perform many of the tasks you may want to
do next, including:
Configure the Multipoint.
Observe and check the connections.
Examine initial conditions.
Set monitoring intervals.
38
WARNING: Make sure that you have tagged, labeled,
and installed appropriate warning signs at the
monitoring location. Individuals entering the area may
be unaware of the high voltages involved in monitoring.
Advertisement
Table of Contents
