Advertisement
Quick Links
Advertisement
Related Manuals for Bon Pergola DM45EAF/S
Summary of Contents for Bon Pergola DM45EAF/S
- Page 1 BON PERGOLA...
- Page 2 STEP1...
- Page 3 STEP2 cross countersunk head self-drilling...
- Page 4 STEP3 cross countersunk head self-drilling 24” 24” hole 7/9” 24” 24” motor...
- Page 5 STEP4...
- Page 6 STEP5...
- Page 7 STEP6...
- Page 8 STEP7...
- Page 9 STEP8...
- Page 10 STEP9...
-
Page 11: Safety Note
DM45EAF/S SAFETY NOTE 1. This appliance can be used by children aged from 8 Instruction A-01 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. -
Page 12: Motor Installation
Wiring Important Safety Instructions To Be Read Prior To Operation. Three wires: 230V/50Hz Setting Notice Neutral line = Blue Please read following points of attention carefully before setting. Live line = Brown Motor 1. Pls take the wire connnector to protect the extra free wires. Earth line = Green Yellow 2. - Page 13 Setting Upper and Lower Limits Activate / Deactivate Jog / Tilt Mode 1 Manually set upper limit 2 Manually set lower limit Press and hold UP and DOWN buttons simultaneously for 5S (1 jog), → press STOP (1 jog and long beep once), Jog / tilt mode is activated. →...
-
Page 14: Troubleshooting
12 Signal Repeater Function Quick Index Press P2 button once(1 jog and 1 beep), press and hold P2 button 5S Settings Steps (2 jogs and 3 beeps ), the signal repeater function has been activated. If motor(1 jog and long beep once), the signal repeater function has been Pairing (hold down 2s) →...
Need help?
Do you have a question about the DM45EAF/S and is the answer not in the manual?
Questions and answers
Hi I need help with a motor that is going in the wrong direction and the hold up and down option is not responding
Possible issues with the Bon Pergola DM45EAF/S motor going in the wrong direction and not responding to the hold UP and DOWN option include:
1. The motor is not paired correctly with the emitter.
2. The motor is out of radio control range.
3. Multiple motors are paired to the same channel, causing interference.
4. The emitter battery may be low and needs replacement.
5. There could be radio interference or shielding issues.
6. The motor limits may not have been set correctly or need to be adjusted.
To resolve this, check the emitter pairing, ensure the motor is within range, use individual channels for each motor, replace emitter battery, and verify proper limit setting.
This answer is automatically generated