Applying Thermal Compound; Attaching The Water Block - ekwb EK-Quantum Vector2 FE RTX 4090 D-RGB User Manual

Gpu water block

Hide thumbs Also See for EK-Quantum Vector2 FE RTX 4090 D-RGB:

Table of Contents

APPLYING THERMAL COMPOUND

STEP 1

Apply the enclosed thermal grease (thermal compound) on the

GPU heat spreader – IHS – as shown in the image. The layer of the

thermal compound must be thin and even over the entire surface

of the IHS.

For this step, you will need:

Thermal Grease

STEP 1

Carefully position the water block with preinstalled standoffs on

the graphics card. During this process, make sure you have aligned

mounting holes of the PCB with holes of the water block.

STEP 1

- 10 -

The excessive or uneven application of thermal grease

may lead to poor performance!

Pay attention not to use too much force when pressing

the block down to the PCB since chip dies are prone

to cracking.

Before attaching the PCB to the Water Block, make sure

all the Thermal Pads are placed correctly!

Table of Contents

Do you have a question about the EK-Quantum Vector2 FE RTX 4090 D-RGB and is the answer not in the manual?