Applying Thermal Compound; Cutting Thermal Pads; Placing Thermal Pads On Pcb - ekwb EK-Pro GPU WB RTX 6000 – Ni + Inox Installation Manual

Gpu water block
Table of Contents

Advertisement

Thermal Pad F 1.0mm
120
Thermal Pad F 0.5mm
120
F 1.0 mm
F 0.5 mm
STEP 3
16
16
STEP 4
STEP 5
STEP 3

APPLYING THERMAL COMPOUND

Lightly coat the GPU chip with enclosed EK-TIM Ectotherm thermal
grease. For best performance, EK recommends applying thermal
grease in the form of a cross (see sample image).
STEP 4

CUTTING THERMAL PADS

Your GPU water block comes with thermal pads that have to be cut into
smaller pieces to cover all the VRM components. You must remove the
protective foil from both sides of the thermal pad before installation.
Replacement thermal pads:
1. Thermal Pad F 1.0mm – (120x16mm) – (EAN: 3830046996732)
2. Thermal Pad F 0.5mm – (120x16mm) – (EAN: 3830046996725)
STEP 5

PLACING THERMAL PADS ON PCB

Once cut to size, thermal pads should be placed on the PCB, as illustrated
below. EK made sure to provide you with more than an adequate quantity
of thermal pads to complete this Step.
- 5 -

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EK-Pro GPU WB RTX 6000 – Ni + Inox and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents