Attaching The Backplate; Inserting The Graphics Card Into The Chassis - ekwb EK-Quantum Vector2 FE RTX 4090 D-RGB User Manual

Gpu water block

Hide thumbs Also See for EK-Quantum Vector2 FE RTX 4090 D-RGB:

Table of Contents

ATTACHING THE BACKPLATE

Carefully lift your graphics card with the installed water block and

insert it into your PC's motherboard PCI Express expansion slot.

Please keep in mind that your graphics card is heavier than before it

was equipped with the water block.

You need to be very careful when handling the graphics

card. Avoid all unnecessary manipulation of the water block

assembly that might damage your card or water block.

STEP 1

Position the I/O Bracket and backplate (including screws and

BACKPLATE

standoffs) onto the GPU PCB. Make sure all the holes are aligned.

Tighten the screws evenly.

Before attaching the backplate, make sure all the Thermal Pads

are placed correctly!

Do not use excessive force!

For this step, you will need:

I/O

BRACKET

STEP 1

- 13 -

Phillips Head Screwdriver

Table of Contents

Do you have a question about the EK-Quantum Vector2 FE RTX 4090 D-RGB and is the answer not in the manual?