Troubleshooting - Teac MC-DV610 User Manual

Troubleshooting

Before resorting to maintenance service, please kindly check by
yourself with the following chart.
Symptom
No power
No picture
No sound
Distorted picture
Luminance unsteady
or picture with noise
Unable to play
Key malfunction
Remote control
Doesn't work
Can't locate any channels
in tuner mode
Cause(s)
The power cord isn't connected
Fuse melting
TV video setup isn't correct
Player video setup isn't correct
Video cable isn't connected well
Audio cable isn't connected well
Source select incorrect
Audio setup isn't correct
Dirty disc
In fast forward or fast rewind mode
Anti-copy circuit influence
Without disc
Disc is bad
Disc is put upside down
Dirty disc
There are menu on TV screen
Parental control is working
Power wave or other static interference.
Doesn't work
Remote control is too far from DVD unit
Batteries are exhausted.
Antenna is not connected
Source mode is not in tuner mode
Connect the power cord properly
Replace a same specification fuse!
Select the suitable setup
Select the suitable setup
Connect the cable properly
Connect the cable properly
Switch to the proper source
Select the suitable audio setup
Clean the disc
Sometimes, the tiny distortion appears. It's normal
Connect the DVD unit to TV directly
Load the disc
Clean or replace the disc
Load the disc properly
Clean the disc
Use SETUP to turn off menu
Set up parental off or change the setup
Turn on/off the power and try again.
Point the remote control at the sensor
Operate the remote control within 7m
Replace the batteries
Connect antenna
Switch to tuner mode
-18-
Solution