Connect The Printer With Usb; About Bluetooth Communications - Intermec PR2 User Manual

Connect the Printer with USB

About Bluetooth Communications

PR2 and PR3 Mobile Receipt Printer User Manual
8 Install the appropriate driver for your printer:
• If you are running Windows XP, the Found New Hardware
Wizard appears. Follow the steps in the wizard. When you are
prompted for the driver location, specify the location of the
InterDriver installation files (C:\Intermec\InterDriver7\).
• If you are running Windows 7, a message appears:
"Device driver software was not successfully installed."
Navigate to the location of the InterDriver installation files
(C:\Intermec\InterDriver7\), run DriverWizard.exe, and follow
the steps in the wizard.
The printer supports USB connections to a desktop PC.
Note: You must use Intermec InterDriver to install the appropriate
driver software on your PC use a USB connection to a Windows PC.
1 Connect a USB cable from the USB device port on the printer to a
USB port on the desktop PC.
2 Turn on the printer. A "New device found" message appears on
your desktop PC screen.
When Bluetooth is enabled, you can connect the printer to other
Bluetooth devices, such as bar code scanners. You can also make the
printer discoverable by Bluetooth-enabled devices such as mobile
computers. You configure Bluetooth communications using PrintSet
5.1 or later through a USB connection to your host PC.
Chapter 2 — Connect and Configure the Printer
15