How To Install Your Canopy Housing; How To Assemble Your Ceiling Fan Blades - Fanimation FPD7617MWW Manual

How to Install Your Canopy Housing

NOTE: This step is applicable after the neccessary
wiring is completed.
1. Assemble canopy by rotating key slot in canopy
over shoulder screw in hanger bracket, taking care
not to pinch the wires. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that was
previously removed. (Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2. Securely attach and tighten the canopy screw
cover over the shoulder screws in the hanger bracket
utilizing the key slot twist-lock feature. (Figure 2)

How to Assemble Your Ceiling Fan Blades

INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
1. Position blade along the motor, aligning blade
holes with holes in the top of the motor assembly
flywheel. Make sure the blade is fully seated against
the flywheel and install 3/16˝-24 truss head screw
with spring washer/flat washer/rubber washer from
the hardware bag. (Figure 1)
3/16˝-24 Truss Head Screw
With Spring Washer/
Flat Washer/Rubber Washer
12
Figure 1
Canopy Screw
Cover
Figure 2
3/16˝-24 Truss Head Screw
With Spring Washer/
Flat Washer/Rubber Washer
( 2 each per blade)
Motor
Figure 1
HARDWARE USED:
Ceiling
Canopy
Blade
x 6