How To Hang Your Ceiling Fan - Fanimation FPD7617MWW Manual

Pc/dc nl ceiling fan

Hide thumbs

Table of Contents

Available languages

WARNING

To avoid possible fire or shock, be sure electricity is

turned off at the main fuse box before hanging.

(Figure 1)

NOTE: If you are not sure if the outlet box is grounded,

contact a licensed electrician for advice, as it must be

grounded for safe operation.

WARNING

The fan must be hung with at least 7' of clearance from

floor to blades. (Figure 2)

CAUTION

Do not connect fan blades until the fan is completely

installed. Hanging fan with blades connected may

result in damage to the fan blades.

Securely attach the hanger bracket to the outlet box

using the #8-32 outlet box screws and flat washers

supplied with the fan. (Figure 3)

Drill a 1/4" pilot hole into the building structure to

prevent splitting or cracking with installation of the lag

bolt. Using the 3/8" x 2" lag bolt and flat washer, attach

safety cable to ceiling joist or wood structural member.

The lag bolt will pass through the flat washer, safety

cable loop, and into the building structure. (Figure 3)

NOTE: Ceiling support cable cannot be secured to

outlet box only, it must be directly secured to ceiling

joist or structural member using the 3/8" x 2" lag bolt

and flat washer. (Figure 3)

Make sure the electrical supply wires, including the

hanger bracket grounding wire and safety cable are

pulled through the downrod, between the hanger

bracket and the outlet box so that electrical

connections can be made later.

WARNING

The outlet box must be securely anchored. Hanger

bracket must seat firmly against outlet box. If the

outlet box is recessed, remove wall board until bracket

contacts box. If bracket and /or outlet box are not

securely attached, the fan could wobble or fall.