Panasonic AG-DV2500P Service Manual page 26

1.8.8 OTHERS menu
Item
OFF
MEMORY SW
LOAD
START
MEMORY SW OFF
SAVE
START
CANCEL
ALL RESET
I,U,E,EC
MEM.EDIT Contents of the EEP-ROM can be edited directly
Operation procedure
1
2
3
4
5
6
(NOTE)
The EEPROMs store important data for the system and careless rewriting may make normal operation of the
system impossible. Do not use this function for purposes other than the IEEE1394 ID date that is described.
OPERATION CANCEL
CHECK
EXECUTE Enters the OPERATION check mode. All LEDs turn on. By operating the relevant buttons and slide
SERIAL
REAR SER.
SEL
TCCS
Standard setting
Menu SW information is loaded from a store aria.
Standard setting
Menu SW information is saved to a store aria.
Standard setting
Resets all EEP-ROM data to default settings except adjustment data, hour meter data, and
IEEE1394 ID data.
Default settings differ by market region.
I: for Japan, U: for USA, E: for EU, EC: for China
ADR: Address (0-03FF) display
DATA: Display of data embedded in address shown by ADR
Press the 8 or 9 button to move the cursor to MEM or EDIT.
Press the : button to make the ADR parameter blink.
Press the 8 or 9 button to select the ADR parameter you want to edit. (Pressing 8 or 9 while keeping
the "A.DUB" button pressed will cause it to count up or down in increments of 10.)
Press the : button to make the DATA parameter blink.
Press the 8 or 9 button to make changes in the DATA parameter.
Press the [SET] button and confirm the DATA parameter. (The parameter stops blinking)
Standard setting
switches, the operation of the buttons and LEDs can be checked as shown in the following list.
To exit from this mode, turn OPERATE to OFF.
Button
OPERATE
EJECT
STOP
FF
PLAY
REW
PAUSE
REC
A.DUB
INPUT SELECT
REMOTE/LOCAL
NTSC/PAL(REAR)
REAR terminal is used as the SERIAL REMOTE terminal.
REAR terminal is used as the TCCS terminal (factory use)
By pressing REC + ADB simultaneously while powering up, the forced TCCS mode is engaged.
Table 1.8.8 OTHERS Menu Setting Items List
Parameter
LED display contents
Power ON/OFF SW
Cassette tape LED goes out
All except OPERATE LED go out
FF LED goes out
PLAY LED goes out
REW LED goes out
PAUSE LED goes out
REC LED goes out
A.DUB LED goes out
Rch LED comes on, Lch LED comes on
DV
Rch LED comes on, Lch LED goes out
LINE
Rch LED goes out, Lch LED comes on
Y/C
DV CAM LED comes on, REC INH LED goes out
9PIN
DV CAM LED goes out, REC INH LED comes on
SERIAL
DV CAM LED comes on, REC INH LED comes on
WIRELESS
NTSC LED comes on, PAL LED goes out
NTSC
NTSC LED goes out, PAL LED comes on
PAL
is default setting when shipped from factory
1-15