Table of Contents
Advertisement
No.
Item
e
25
FPC1 assembly
FPC1
26 FPC2 assembly/ FPC3 assembly
FPC2
2-22
Ref. Illustration
Idler cover
Match the hole to the boss
of an idler cover.
M.I.C connector
Soldering on the reverse.
Fig. 2.6.25
FPC3
Fig. 2.6.26 (1)
Procedure
<Disassembly>
1) Remove the M.I.C connector and idler arm assem-
bly as described in section 2.6.7.
2) Remove solder from the M.I.C connector (6 posi-
tions).
3) Remove the FPC1 assembly by performing the
same operation as peeling adhesive tape off for
the idler cover section.
<Assembly>
1) Reverse the disassembly procedure.
Note:
Do not reuse the removed FPC1 assembly.
<Disassembly>
FPC2 assembly:
1) Remove solder from CN126 on the mechanism
board.
2) Remove the FPC2 assembly as if peeling adhesive
tape off.
FPC3 assembly:
1) Remove solder from CN127 on the mechanism
board.
2) Remove the FPC3 assembly as if peeling adhesive
tape off.
<Assembly>
1) Reverse the disassembly procedure.
Note:
Do not reuse the removed FPC1 and FPC2 as-
semblies.
CN127
Fig. 2.6.26 (2)
CN126
Advertisement
Chapters
Table of Contents
