Panasonic AG-DV2500P Service Manual page 19

1.8.3 VTR 1 menu
Item
REC REPEAT
FOOT SW LEVEL
MIC REC CH
ID 422 (H)
ID 422 (L)
FF/REW SPEED
DV DF MASK (PAL only)
1.8.4 VTR 2 menu
Item
LONG PAUSE
REC MODE
LP WARNING
TEST SIGNAL
TEMP THRESHOLD
BATT. SHUT DOWN
BATT. ALARM
1-8
OFF No repeat recording
2 Repeat recording 2 times
12 Repeat recording 12 times
ON Full repeat recording
LEVEL1 Possible from any mode
LEVEL2 Possible only from STOP or REC PAUSE mode
NORMAL Record input signal from connected MIC only on CH2 (CH4 : during A.DUB mode)
CH1-MIX [No recording mode]. Do not record input signal from connected MIC on CH1/CH2
(No recording on CH3+4 during A.DUB)
CH2-MIX Record input signal from connected MIC on CH1/CH2 (CH3/CH4 during A.DUB)
F0 High Device ID (00~FF). First bit is fixed at PAL1, NTSC0
4E Low Device ID (00~FF)
x50 Maximum FF/REW speed is regulated to x50
x75 Maximum FF/REW speed is regulated to x75
x100 Maximum FF/REW speed is regulated to x100
MAX No maximum FF/REW speed regulation
OFF "1" is recorded as per format
ON "0" is always recorded
Table 1.8.3 VTR 1 Menu Setting Item List
OFF Disables long pause function
ON Enables long pause function
SP SP recording
LP LP recording (Do not change since performance cannot be guaranteed)
OFF LP INH not displayed (Enables playback with LP mode) (Do not change since
performance cannot be guaranteed)
ON LP INH displayed (Disables playback with LP mode)
OFF Output color bars only. Do not output any other TEST signals.
ON Use BARS button of a attached wireless controller reception to trigger output TEST
signal, rotating in this order:
Color bars
track) Multi burst (Y signal only)
Red Black burst
220 Threshold of rising temperature warning display, 00~255 (220 [DCh] = internal
temperature approx. 60°C). Refer to item "TEMP" in table 1.8.7 (1)
10.5 Voltage value to carry out power OFF operation (Set at OFF, 10.0~12.0 in
increments of 0.1)
11.0 Voltage value to trigger display of battery alarm warning (Set at 10.0~12.0 in
increments of 0.1)
Table 1.8.4 VTR 2 Menu Setting Item List
Parameter
is default setting when shipped from factory.
Parameter
Color bars (rotate per track)
Multi burst (Y and C signals)
is default setting when shipped from factory.
Grayscale Grayscale (rotate per
100% white