Flashforge Guider User Manual page 70

needed. Press down the left mouse button and drag to generate the support.
2）Manual Delete
Like the picture above, a hole inside the model doesn't need any supports.
Left click the [Delete] button and then left click the supports needed deleting. And the
support will be deleted.
7.2 Control over Printing Quality
① Enhance the build plate adhesiveness
● Leveling the build plate
● Keeping the build plate smooth and tidy
● Using the build tape or glue
② Adjusting the printing speed
● Low (Fast) (Print Speed 100mm/s Travel Speed 120mm/s)
● Standard (Print Speed 80mm/s Travel Speed 100mm/s)
● High (Slow) (Print Speed 60mm/s Travel Speed 80mm/s)
● Hyper (Print Speed 40mm/s Travel Speed 60mm/s)
7.3 Skills of Model Placement
Not all the models are in the right positions after being loaded. Therefore, you need to
place it in an appropriate position for better print quality. Such as the models below,
Guider User Guide | www.ff3dp.com
69