Marantz PM7000N Service Manual page 61

Network integrated amplifier
Hide thumbs Also See for PM7000N:
Table of Contents

Advertisement

5. Normal Firmware Update Method from USB Flash Drive (NETWORK MODULE)
5.1. File structure on USB flash drive
Copy the normal update files onto the USB flash drive in the following structure.
After unzipping the HW component USB update files for the target model and Network USB update
files, store them in the root of the same USB flash drive.
Model Area
For HW component
DPMS_PM7000NALL_LEGO_xxx.zip
North America (U)
Product ID : 100200140100
DPMS_PM7000NALL_LEGO_xxx.zip
Europe (N)
Product ID : 100200140200
DPMS_PM7000NALL_LEGO_xxx.zip
Japan (F)
Product ID : 100200140400
USB flash drive root
+PM7000Nxx_xxxx.update.forced
+FirmInfo.xml
+heos_40.prod.update.x-xxx-xx
5.2. Start normal update
NOTE :
• Remove the LAN cable from this unit when updating.
(Do not connect to a wired or wireless network.)
• Do not remove the USB flash drive until updating is completed.
• Do not turn off the power until updating is completed.
• It takes a maximum of approximately 10 minutes for update to complete.
Once an update is started, normal operations cannot be performed until it is completed.
The menu settings and image adjustment settings of this unit may be initialized.
Note down the settings before updating, and set them again after updating.
Download from SDI
For Network component
heos_40.prod_x.xxx.xx.zip
(1) Press the power operation button to turn off the power, and remove the AC plug from the socket.
(2) Insert the AC plug while pressing buttons "SOURCE DIRECT" and "ENTER" together, and wait for
more than 3 seconds.
(3) "All Device USB Update" is displayed.
•It takes approximately 90 seconds to start up the network device.
(4) Insert the USB flash drive into the USB port.
Download firmware
in USB flash drive.
(5) USB Update starts automatically.
The Standby LED lights red.
Display during USB update
It takes a maximum of approximately 11 minutes for update to complete.
(6) The unit restarts when update is complete.
(7) After updating the firmware, check the version.
See
"1-1. Version Display
Mode"
61

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents