Kobalt KIW 124B-03 Manual page 12

OPERATING INSTRUCTIONS
NOTICE:
• The LED indicator will turn off within approximately 1 min after the variable-speed trigger
switch or mode button is released, and will revert to the previous setting when the tool is
turned on again.
MODE APPLICATIONS
"Hand Tightening car wheel lug
Tight" nuts which will later be
checked/tightened with a
torque wrench.
OR
Driving bolt/nut into the
workpiece with good
finish.
"Auto Slow" Removing bolt/nut from
the workpiece in a
controlled manner.
6. LED Work Light
The LED work light (E), located on the base of
the impact wrench, will illuminate when the trigger
switch is depressed. This provides additional light
on the surface of the work piece for operation in
lower-light areas.
The LED work light will turn off after approximately
10 seconds after the variable-speed trigger switch
is released.
a. The LED work light will flash rapidly if the
tool has stopped automatically when the tool
became overloaded or too hot. Please wait for
the tool to cool down, at which point it can be
started again.
b. The LED work light will flash slowly to indicate
that the battery charge is very low. Please recharge the battery pack.
FEATURE
The tool will stop
rotating soon
after impact
mechanism is
engaged.
The tool will slow
down the speed
as soon as the
bolt/nut is loose.
6
12
FUNCTION
This mode allows the user to
work fast with precision while
not damaging the workpiece.
It helps to prevent over-
tightening of the bolt/nut and
damage to the workpiece
surface.
NOTE: The timing to stop
the driving varies depending
on the type of the bolt/nut
and material to be driven in.
Perform a test driving before
using this mode.
This mode helps to prevent
the bolt/nut from falling or
being thrown out of the
socket.
E