Connecting The Pump; Connecting The D-Rgb Led Strip - EK-Quantum Velocity2 DDC 4.2 PWM D-RGB - 1700 User Manual

CONNECTING THE PUMP

SATA
CONNECTOR

CONNECTING THE D-RGB LED STRIP

4-PIN PWM FAN
CONNECTOR
D-RGB HEADER
RGB HEADER
STEP 1
The EK-DDC PWM has two connectors.
1. SATA Connector: It must be connected directly to your PSU at
times as it is used to power the pump.
2. 4-pin PWM fan: It can be connected to your motherboard's
CPU_FAN or designated water pump hader. It can also be
connected to a controller. This cable is used to control and
report the rotational speed of the pump. If it's not connected,
the pump will run at the maximum speed (100% PWM).
STEP 1
Plug the 3-Pin connector from the water block's D-RGB LED light to
the DRGB HEADER on the motherboard. The LED will work if the pin
layout on the header is as follows: +5V, Digital, empty, Ground.
Please ensure that the arrow indicated on the connector is
plugged into the +5V line as indicated on your motherboard.
If you put the LED Diode to the 12V RGB HEADER you
can damage the LEDs. Failure to do so will damage your
motherboard or LED strip.
- 11 -