EK-Quantum Velocity2 DDC 4.2 PWM D-RGB - 1700 User Manual page 9

MAX TORQUE:
0.6 Nm
1
4
3
2
STEP 3
Position the CPU Water Block onto the Motherboard. Make sure to
align the holes (as shown in the picture).
STEP 3
STEP 4
TOP OF THE
After placing the water block, the stored backplate must be attached
MOTHERBOARD
on the backside of the motherboard using Allen Key 2.5 mm (shown
in the picture).
Start fastening the backplate screws in a cross pattern. Do not
tighten fully until all of the nuts are partially screwed in. The Allen
Key 2.5 mm must be used in a standing position! Otherwise, the
mounting screws may crack during tighteening!
EK recommends using the EK-Loop Torque Screwdriver - 0.6Nm :
https://www.ekwb.com/shop/ek-loop-torque-screwdriver-0-6nm
STEP 4
- 9 -
Make sure to double check the layer of the Thermal Grease
before placing the water block onto the motherboard.
Make sure to orientate the backplate as illustrated.
Incorrect installation of the backplate may result in
damage to the motherboard.