TAKAYA APT-9411 Series Operator's Manual page 27

5. It displays Fig.63. Open the safety cover and take the pc board out of the tester.
Then close the safety cover and depress [RESET] SW, and depress [TEST START] SW.
6. It displays Fig.64.
7. Open the safety cover and place the bottom probe #1 under the target mark whilst monitoring the
camera screen. The close the safety cover and depress [RESET] SW, and depress [TEST START]
SW. And it displays Fig.65.
8. Open the safety cover and place the bottom probe #2 under the target mark whilst monitoring the
camera screen.
9. Repeat the same operation to install the bottom probe #3,4.
After all the bottom probes were installed on the predefined positions, close the safety cover and
depress [RESET] SW, and depress [TEST START] SW. Now you were able to complete the
installation of your bottom probes.
Particular care should be paid to the keen-edged head of the bottom probes to be
installed. Otherwise it may be an injury to your body.
If you fill the box " Use Bottom probes" in Data mode and save the test program, the
Bottom probe setting menu below will appear automatically following the Board
reference point setup operation after the test program was loaded.
APT-9411 Extension Scanner Board
[Fig.63]
[Fig.64]
[Fig.65]
- 25 -