TAKAYA APT-9411 Series Operator's Manual page 14

3. Select [Bottom Set] from the pull-down menu, and it displays the Bottom probe setting screen.
Fill either the box " Polarity +" or " Polarity – " that should be changed from the flying probe to the
4.
extension bottom probe. In the coordinates shown in Fig.31, Probe 1 is " Polarity +" and Probe 4 is
" Polarity – " .
Fill the box " Polarity +" and select " Extension Scanner(64pin)" from the right pull-down menu.
5.
6. Specify the extension bottom probe to use.
Only if you want to use the extension bottom probe for " Polarity -" as well, select " Extension
7.
Scanner(64pin)" from the right pull-down menu and specify the extension bottom probe to use.
(Refer to Fig.34) Then Click the OK button.
[Fig.30] Bottom probe
[Fig.31]
[Fig.32]
[Fig.33]
[Fig.34]
- 12 -