Table of Contents
Advertisement
6. Hardware installation
6.1 Installation Procedures
The manufacturer assumes no liability for any damage, caused directly
or indirectly, by improper installation of any components by
unauthorized service personnel. If you do not feel comfortable
performing the installation, consult with a qualified computer technician.
6.2 Steps:
1.
Turn OFF all powers to your system, including any peripherals
(printer, external drives, modem, etc.).
2.
Disconnect the power cord and the monitor cable from the
back of the computer.
3.
Unfasten the cover mounting screws on your system and
remove the system cover. Refer to your system user manual
for instructions to determine the location of the mounting
screws.
4.
Remove any graphics adapter that already installed on your
motherboard. Start by removing the screw that holds the
adapter retaining bracket in place (keep this screw, you will
need it later). Then, gently pull straight up on the adapter
card itself, and remove it from the motherboard.
5.
Refer to your computer system manual for the location of the
AGP bus expansion slots. Remove the retaining screw that
holds the slot cover in place. Slide the slot cover out and put
the screw aside (you will need it to secure the adapter).
If you just removed an existing graphics adapter and are not
going to use that expansion slot, you can install the slot cover
!! WARNING !!
Discharge static electricity by
touching the GROUND such as
metal part of your case connected
with good power ground before
you handle the electronic circuit
21
boards.
Advertisement
Table of Contents
