Installation - GE 45130 User Manual

Preparing the Garage Door Sensor for Installation
The Garage Door Sensor is a self-contained Sensor.
Before installing open the battery door and, remove
the yellow battery isolation tape from the Garage
Door Sensor. This activates the Lithium battery inside
the Garage Door Sensor. The approximate battery life
is up to two years. When replacing the battery it is
recommended to replace all Sensor batteries at the
same time in order ensure proper operation of the
entire system.
Note: When using doublesided tape apply to clean dry
surface.
The Garage Door Sensor is intended to be positioned
on the interior side of the garage door at the bottom.
The Garage Door Sensor must be mounted vertically
so the detection cylinder is able to move freely up and
Open
Closed
down. Select a position on the garage door frame
near bottom edge. To not damage the Garage Door
Sensor when the door closes, position the Garage
Door Sensor with the detection rod retracted and the
6