MTI FREEDOM MICRO II Power Product Manual page 7

REMOVING SPEEDPLATE™
1
Place the VHB removal tool around the SpeedPlate™,
3
Roll any remaining adhesive off of the device.
REMOVING PUCK FROM TETHER
1
Lift puck out of riser, insert the crescent end of the
Freedom Micro II tool into the opening below the
charge port on the puck. Twist the Freedom Micro II
tool counterclockwise to unlock the puck from the
tether.
www.MTIGS.com | T:800.426.6844
FREEDOM MICRO
2
Pull the tool, working it back and forth like a saw, until
the SpeedPlate™ comes off the devices
- (Applies to Micro II Power, Micro II HS Power)
2
Once the puck is loose, rotate the puck 45 degrees
counterclockwise in relation to the tether. Lift the puck
off of tether connection.
® II POWER MANUAL
MTI P/N 063-00425 rev A ©2022 MTI All Rights Reserved
7