Kohler C3-300 Homeowner's Manual page 24

TROUBLESHOOTING (cont.) / 疑难解答（续）
Clean Functions
Phenomenon
6. No water flow.
7. Low spray water
pressure.
8. Water stops
spraying from
the nozzle before
wash finishes.
9. Water comes
out from the hole
beside the nozzle
during spraying.
10. Water comes
out from the nozzle
when the product is
seated on.
Slow Seat Closure
Phenomenon
11. The speed of
the seat and cover
closure varies
in summer and
winter.
Seat-on Sensor
Phenomenon
12. Clean function
operates when
pressing spray
button while the
seat is not in use.
1367362-T01-E
Possible Causes
A. The water supply valve is
turned off.
B. The seat-on sensor fails to
detect the user.
A. Filter is clogged.
B. Insufficient water supply
pressure.
A. Spray function auto stops
after continuous spraying for 1
min.
B. The seat-on sensor fails to
detect the user.
A. A protection method from
high pressure inside the
product.
A. Residual water in the wand
is auto-drained before the user
resumes using the product
after a long time.
Possible Causes
A. Due to changes in room
temperature.
Possible Causes
A. The seat-on sensor is
covered by an object or the
seat is wet.
Recommended Solution
A. Open the water supply valve.
B. Check how to activate
the seat in "INSTALLATION
INSPECTION" section.
A. Refer to "CLEAN FILTER"
section.
B. Raise water pressure into
the pressure range required
by the product.
A. If needed, press the spray
button again.
B. Check how to activate
the seat in "INSTALLATION
INSPECTION" section.
A. Normal phenomenon.
A. Normal phenomenon.
Recommended Solution
A. Normal phenomenon.
Recommended Solution
A. Remove water or objects
from the seat-on sensing area.
24 Kohler Co.