Joy Sport Basic Pro User Manual page 18

STEP 3
1. Place 50mm square cap (41) into both ends of top cross beam (12).
2. Attach top cross beam (12) onto the verticle beam (10) from top side and connect the
guide rods (2) to the top cross beam (12) as shown.
3. Attach rubber bumper (37) to the verticle beam (10).
4. Attach pulley block (21) to the verticle beam (10), use M8*65mm bolt (57) with M8
washer (69) and M8 nuts (64).
5. Intsall press pin (18) to the verticle beam (10) with M8*65mm bolt (57), M8 washer (69)
and M8 nuts (64).
7