STEP 2
1. Attach the rubber dount (9) into the guide rod (2).
2. Slide the weight plate (8) and top plate (6) over guide rod (2).
Groove for selector pin on weight plates should face down.
3. Install 1'' round bushing (38) into the selector shaft (5) with pin (47) then attach the
selector shaft (5) into the top plate (6).
4. Place 50mm square cap (41) into both ends of front base (1).
5. Place rubber cap (70) into both ends of right base (4).
6. Attach right base (4) to main base (1) as shown.
6