Table of Contents
Advertisement
34
EN
Recording
Features
1
4
7
C.RESET
1
Record One Program While
Watching Another
ENGAGE TV MODE
1
During recording...
Press TV/VCR. The VCR's VCR indicator goes out. (If
you are using the RF connection (
the output from your VCR, the TV broadcast being
recorded disappears.)
If you are using the AV connection (
the output from your VCR, change the TV's input
mode from AV to TV.
SELECT CHANNEL FOR
VIEWING
2
Use the TV's channel selector to set the channel you
want to watch.
PLAYBACK AND RECORDING FEATURES (cont.)
DISPLAY
2
3
2
5
6
8
9
0
4
pg. 6) to view
pg. 6) to view
Display Elapsed Recording
Time
RESET COUNTER TO ZERO
1
Before recording starts, press C.RESET. The counter
resets to zero and displays the exact elapsed time as the
tape runs.
DISPLAY ELAPSED TIME ON
SCREEN
2
During recording, press OSD at any time to see the
elapsed time.
All indications corresponding to the current status of the
VCR are displayed for 5 seconds. The counter display
remains on the screen indicating the elapsed time.
Press OSD again to remove the display.
Make sure "SUPERIMPOSE" is set to "ON" (
The indications are not recorded.
Press DISPLAY to change to the COUNT display if
"REMAIN" is displayed.
Display Tape Remaining Time
DISPLAY COUNTER
INFORMATION
1
Press OSD.
All indications corresponding to the VCR's current
status are displayed for 5 seconds. The counter display
remains on the screen indicating the elapsed time.
DISPLAY TAPE REMAINING
TIME
2
Press DISPLAY until "REMAIN" appears on screen. The
approximate tape remaining time appears on the TV
screen and also on the VCR display panel with a "
indicator.
The tape remaining time is calculated based on the
tape speed (SP or EP) being used. The indicated
remaining time is only an estimate.
Press DISPLAY to change the on-screen display from
REMAIN to COUNT and vice versa; and to show
counter reading, channel number, clock time or tape
remaining time on the front display panel. Then
channel number will not be displayed when the VCR
is playing a tape.
EXIT THE DISPLAY
3
Press OSD again.
NOTES:
"SUPERIMPOSE" must be set to "ON", or the on-screen
display will not appear (
Near the beginning of the tape, the tape remaining estimate
may be inaccurate. However, the estimate becomes more
accurate as the tape comes closer to the end.
Depending on the type of tape used, the tape remaining time
reading may not appear right away, or may not be correct. "- -:- -"
may sometimes appear, or the display may blink on occasion.
The tape remaining time indication is not accurate when using
VHS-C tapes with VHS-C adapter.
pg. 29).
pg. 29).
"
Advertisement
Table of Contents
