Entry And Exit Delay - Chuango WS-105 User Manual

EN
Connect Wireless Accessories
Firstly, press the connect button (0.5 seconds), the wireless siren
beeps once. 3 seconds later, it gives out another beep and the
strobe light flashes, then the siren goes into connecting status.
Secondly, trigger the wireless accessory once (such as press any
button on the remote control / separate the transmitter and magnet
of the door contact / press the test button of motion detector), and
it will be connected after one beep. Repeat the above operation to
connect other accessories.
Note: The siren supports up to 40 wireless accessories.
Testing:
Press the [Arm] button on the remote control, if the wireless
siren flashes once, it means the connection of remote control
is successful. Then trigger the sensor, siren will hoot. If not, the
connection fails, please reconnect.
Delete All Accessories or Panels
If you lose the wireless accessories especially the wireless remote
controls, it is recommended to delete all the accessories and then
re-connect for safety.
Press down the connect button for 6 seconds until one beep is
heard, at the same time, the LED indicator flashes twice, it means all
connected accessories and panels are deleted.

Entry and Exit Delay

Entry and exit delay time can be set if you do not want to take the
remote control.
After setup, if you arm the system, the siren beeps once every
5 seconds until it goes to arm state. If the detectors (except those
in 24-H zone) are triggered, the siren will sound the alarm after the
delay time. (Siren ringing time is 3 minutes). The setup method is as
below:
Press Connect Button twice, delay 30 seconds.
Press Connect Button three times, delay 60 seconds.
Press Connect Button four times, no delay.
Default setting: No delay.
Note: Press the [Arm] button on the remote control twice, the system
switches to arm state immediately.
Switch On/Off Night Lamp
When the siren working as a standalone alarm, it can also be used
as a LED night lamp.
Press the [Stay] button on the remote control, its LED indicator
blinks once, and then press the [Stay]
3 seconds, the siren switches to home mode silently and the night
lamp is on. Press [Disarm] button, the siren will be disarmed and
the strobe light will be switched off.
EN
button again within