ENGLISH (Original instructions) SPECIFICATIONS Model MT900 MT901 Depressed center wheel diameter 180 mm 230 mm Spindle thread Rated speed (n)/No load speed (n 8,500 min 6,600 min Overall length 468 mm 468 mm Net weight 5.5 kg 5.8 kg Safety class •...
Page 3
Designation of Machine: tools. Unmodified plugs and matching outlets will Angle Grinder reduce risk of electric shock. Model No./ Type: MT900,MT901 Avoid body contact with earthed or grounded are of series production and surfaces such as pipes, radiators, ranges and Conforms to the following European Directives: refrigerators.
up or carrying the tool. Carrying power tools with Service your finger on the switch or energising power tools 25. Have your power tool serviced by a qualified that have the switch on invites accidents. repair person using only identical replacement 14.
Page 5
the plane of the rotating accessory and run the uncontrolled power tool to be forced in the direction power tool at maximum no-load speed for one opposite of the accessory’s rotation at the point of the minute. Damaged accessories will normally break binding.
Page 6
are of correct size and shape for your selected Safety Warnings Specific Wire Brushing wheel. Proper wheel flanges support the wheel Operations: thus reducing the possibility of wheel breakage. a) Be aware that wire bristles are thrown by the Flanges for cut-off wheels may be different from brush even during ordinary operation.
short-circuit breaker (30 mA) to assure Switch action operator safety. 33. Do not use the tool on any materials 1. Switch trigger containing asbestos. 2. Lock lever 34. Do not use water or grinding lubricant. 35. Ensure that ventilation openings are kept clear when working in dusty conditions.
Page 8
For tool with clamp lever type wheel guard Installing side grip (handle) 1. Wheel guard 2. Bearing box 3. Nut 4. Lever 010644 006773 CAUTION: 1. Nut Always be sure that the side grip is installed 2. Lever • securely before operation. Screw the side grip securely on the position of the tool as shown in the figure.
OPERATION 1. Lock nut 2. Depressed center wheel WARNING: 3. Inner flange It should never be necessary to force the tool. The • weight of the tool applies adequate pressure. Forcing and excessive pressure could cause dangerous wheel breakage. ALWAYS replace wheel if tool is dropped while •...
Page 10
wires. Operation with abrasive cut-off / diamond wheel (optional accessory) 1. Wire cup brush WARNING: When using an abrasive cut-off / diamond wheel, • be sure to use only the special wheel guard designed for use with cut-off wheels. NEVER use cut-off wheel for side grinding. •...