About The Scsi Daisy Chain - JVC XR-D400SLE Instructions Manual

About the SCSI daisy chain

A total of seven SCSI devices may be connected to a single host computer. Take
caution to ensure that each device is set to a different SCSI device ID number.
The unit is provided with a D-sub 50P half-pitched connector and has a built-in
SCSI terminator. Connect the unit as the last device in the chain and set the
TERMINATION switch to ON.
HOST Computer
(with SCSI connector)
Setting the SCSI device ID number
Each SCSI device connected to the host computer must be
given a distinct SCSI device ID number. The unit factory
default SCSI ID number is "0," but you may have to change
this when you connect it to your computer.
To change the SCSI device ID number, use the ID selection
switch.
Information
• For details of the driver software of the unit, see the instruction of the
supplied CD-ROM.
• System supported:
System requirements: Pentium MMX 166, 64 MB RAM equivalent or
•
(recommended)
Windows 98 (includes 2nd edition), Windows 95,
Windows NT 4.0
higher
Using as a CD-R/RW drive
The unit
1 2 3 4 5 6 7 8 9
POWER
11 12 13 14 15 16 17 18 19
SPEED 4x 2x 1x
REPEAT 1 TRACK ALL
PROGRAM
REC
SPEED
REPEAT
SOURCE
SCSI AUTO REC
REC/PLAY
ID
English
10
OVER
20
ERASE
FINALIZE
OPEN/CLOSE
OPEN/CLOSE
25