Table of Contents
Advertisement
Introduction
We would like to thank you for purchasing one of our JVC products.
Before operating this unit, read this manual carefully and thoroughly to obtain the best
possible performance from your unit, and retain this manual for future reference.
About This Manual
This manual is organized as follows:
• You can use the buttons and controls both on the
remote control and on the unit for the same operations
if they have the same or similar names (or marks),
unless mentioned otherwise.
• Basic and common information that is the same for many
functions is grouped in one place, and is not repeated in
each procedure. For instance, we do not repeat the
information about turning on/off the unit and others, which
are explained in the section "Basic Operations" on page 9.
• The following marks are used in this manual:
Gives you warning and caution to prevent
from damage or risk of fire/electric shock.
Furthermore, gives you information which is
not good for obtaining the best possible
performance from the unit.
Gives you information and hints you had
better know.
2
Precautions
Installation
• Install the unit in a place which is level, dry and neither too
hot nor too cold—between 5˚C (41˚F) and 35˚C (95˚F).
• Install the unit in a location with adequate ventilation to
prevent internal heat build-up in the unit.
DO NOT install the unit in a location near
heat sources, or in a place subject to direct
sunlight, excessive dust or vibration.
Power sources
• When unplugging the unit from the wall outlet, always pull
the plug, not the AC power cord.
DO NOT handle the AC power cord with wet
hands.
Moisture condensation
Moisture may condense on the lens inside the unit in the
following cases:
• After starting heating in the room
• In a damp room
• If the unit is brought directly from a cold to a warm place
Should this occur, the unit may malfunction. In this case,
leave the unit turned on for a few hours until the moisture
evaporates, unplug the AC power cord, then plug it in again.
Others
• Should any metallic object or liquid fall into the unit, unplug
the AC power cord and consult your dealer before
operating any further.
• If you are not going to operate the unit for an extended
period of time, unplug the AC power cord from the wall
outlet.
DO NOT disassemble the unit since there are
no user serviceable parts inside.
If anything goes wrong, unplug the AC power cord and
consult your dealer.
Advertisement
Chapters
Table of Contents
