Xblue Networks X16 plus Administration Manual page 23

Name
Outbound Proxy
Port
Register Interval
NAT Refresh
Interval
NAT Refresh
Message
Bind Mode Server
Status Check
Server does not
support send-only
SIP Trunk # Key as
Dialing Ending Key
Reinvite Resend
flag
IPT NAT Traversal
Enable External
Route IP
External Route IP
REFER mode for
IPT to IPT XFR
Short Number
Display
Trunk To Trunk
Media Relay
Trunk CID Through
to trunk
CID Delete Digit
Lengths
CID Insert digit
X16plus Administration Manual
Outbound Proxy Port.
The timing value of register cycle.
Used for some complicated ITSP network topology.
Message type: SIP PING/OPTIONS/NOTIFY/UDP.
The device will send a NAT Refresh message to ITSP Server
periodically to sync session status of each other.
This field is for ITSP Server compatibility. Please enable this
item when ITSP Server does not support Send-Only SIP
specification.
# is a dial out digit or Ending Key.
SIP trunk will re-send INVITE message when the call session
is established.
When ITSP SIP Server does not support NAT Traversal, this
field should be enabled and let system modify SIP signal to do
NAT Traversal on the device.
This field is used for resolving ITSP SIP Server compatibility
issues.
External route IP address.
System will use REFER to implement IP trunk to IP trunk
transfer when this field is enabled.
System will use XD10/IP Phone number for outbound trunk
calling number if it is enabled.
Controls whether the media of the IP trunk to IP trunk call is
relayed by the device.
The outgoing trunk will send the incoming trunk CID when
trunk to trunk status.
CID Delete Digit Lengths.
CID Insert digit.
Page 23 of 54
Description
Rev. 1.1.4