Panic Mode - Clarion UNGO PRO SECURITY SYSTEM K20 Owner's Manual

1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet®
The status LED will light steadily if you are entering Valet
and will turn off if you are exiting Valet
➜

panic mode

If you are threatened in or near your vehicle, you can attract
attention by triggering the system with your transmitter. Just
press for two seconds to enter Panic Mode. In Panic Mode,
the horn will honk (if connected) and the parking lights will flash
for 30 seconds. To stop Panic Mode at any time, press
transmitter again.
note: In order for Panic Mode to be effective, the vehicle's
horn (or optional siren) as well as the vehicle's parking
lights must be connected.
r r a a p p i i d d r r e e s s u u m m e e l l o o g g i i c c
This Pro Security system will store its current state to non-volatile
memory. If power is lost and then reconnected, the system will
recall the stored state from memory. This means if the unit is in
Valet Mode and the battery is disconnected for any reason, such
© 2006 directed electronics, inc.
switch within 10 seconds.
DRW-35
® Mode
® Mode.
on the
9