Using The Remote Control; Putting Batteries In The Remote Control; Operating The System From The Remote Control - JVC TH-V70 Instructions Manual

Getting Started

Using the remote control

The remote control makes it easy to use many of the functions of the system at a distance of up to 7 m (23 feet) away.
• You can also operate other components from the remote control supplied with this system.
– To operate your TV, see page 20.
– To operate your VCR, CATV convertor, or DBS tuner, see page 69.

Putting batteries in the remote control

Before using the remote control, put two supplied batteries first.
1 On the back of the remote control, remove the battery cover.
2 Insert batteries.
• Make sure to match the polarity: (+) to (+) and (–) to (–).
3 Replace the cover.
1
If the range or effectiveness of the remote control decreases, replace the batteries. Use two R6P (SUM-3)/AA (15F) type dry-
cell batteries.
CAUTION:
Follow these precautions to avoid leaking or cracking batteries:
• Place batteries in the remote control so they match the polarity: (+) to (+) and (–) to (–).
• Use the correct type of batteries. Batteries that look similar may differ in voltage.
• Always replace both batteries at the same time.
• Do not expose batteries to heat or flame.

Operating the system from the remote control

Aim the remote control directly at the remote sensor on the center unit.
• To control other components, aim the remote control directly at the remote sensor on each component.
Refer also to their instruction manuals .
• To operate the remote control properly, do not hide the remote sensor by placing any obstruction.
SOURCE
D V D D I G I T A L T H E A T E R
T H - V 7 0
When the center unit is placed vertically
19
2
VOL
Remote sensor
S Y S T E M
3
SOURCE VOL
When the center unit is placed horizontally
NOTE:
When the moving panel is open, the remote
sensor looks up, so the remote control may not
work.
You can use the remote control while the moving
panel is shut.