Advertisement
CAUTION:
Proper
Ventilation
To avoid risk of electric
shock and fire, and to prevent
damage,
locate the apparatus
as follows:
1. Front: No obstructions
and open spacing.
2. Sides/Top/[3ack:
No obstructions
should
be placed
in the areas indicated
by the dimensions
in the illustration.
3. Bottom:
Place on the level surface. Maintain
an adequate
air path for ventilation
by placing on a stand with a height of 10
cm (3-15116") or more.
ATTENTION:
Ventilation
Correcte
Pour _viter
tout risque de choc _lectrique
et d'incendie,
placez I'appareil
en respectant
ce qui suit:
1. Avant:
Rien ne doit g_ner le d_gagement.
2. Flancs/Dessus/Arri&re:
Aucun obstacle
ne doit &tre plac_ dans les zones indiqu_es
par les dimensions
dans
I'illustration.
3. Dessous: Poser I'appareil
sur une surface plate.
Laissez suffisamment
d'espace
pour que la ventilation
puisse
s'effectuer
correctement
en pla(;ant
I'appareil
sur un socle d'une
hauteur
de 10 cm ou plus.
Front / Face
i
15 cm (5-15/16")
15 cm
cm
(5-15/16")
(5-15/16")
(3-15/16")
For U.S.A.
Caution:
Changes
or modifications
not expressly
approved
by party
responsible
for compliance
could
void the user's
authority
to operate
the equipment.
Note:
This equipment
has been tested
and found
to comply
with
the limits for a Class [3digital
device,
pursuant
to
Part 15 of the FCC Rules. These limits are designed
to provide
reasonable
protection
against
harmful
interference
in a
residential
installation.
This equipment
generates,
uses and can radiate
radio frequency
energy
and, if not installed
and
used in accordance
with the instructions,
may cause harmful
interference
to radio communications.
However,
there
is no
guarantee
that interference
will not occur in a particular
installation.
If this equipment
does cause harmful
interference
to
radio or television
reception,
which
can be determined
by turning
the equipment
off and on, the user is encouraged
to
try to correct
the interference
by one or more of the following
measures:
- Reorient
or relocate
the receiving
antenna.
- Increase the separation
between
the equipment
and receiver.
- Connect
the equipment
into an outlet
on a circuit
different
from that to which
the receiver
is connected.
- Consult
the dealer
or an experienced
radio/TV
technician
for help.
Pour les Etats-Unis
Attention:
Les changements
ou les modifications
qui ne sont pas explicitement
approuv_s
par la partie
responsable
de
I'observance
pourraient
mettre
fin au droit
de I'utilisateur
d'utiliser
le materiel.
Remarque:
Cet appareil
a _t_ test_ et il s'est av_r_ conforme
aux limites
applicables
_ un appareil
num_rique
de
classe 13, e n vertu de la Partie
15 des R_gles de la FCC. Ces limites sont con(;ues de mani&re
_ assurer une protection
raisonnable
contre
les interferences
nuisibles
dans une installation
r_sidentielle.
Cet appareil
produit,
utilise et peut
_mettre
une _nergie
de haute fr_quence
et, s'il n'est pas install_
et utilis_ en conformit_
avec les instructions,
il peut
causer des interferences
nuisibles
aux communications
radio. II n'y a, toutefois,
aucune
garantie
que des interferences
ne se produiront
pas dans une installation
particuli&re.
Si cet appareil
cause effectivement
des interferences
nuisibles
la r_ception
de la radio ou de la t_l_vision,
ce qu'on
peut _tablir
en mettant
I'appareil
en marche
et _ I'arr&t, nous
encourageons
I'utilisateur
_ tenter
de corriger
I'interf_rence
par une ou plusieurs des mesures suivantes:
- r_orienter
ou d_placer
I'antenne
de r_ception;
- accroitre
la s_paration
entre
I'appareil
et le r_cepteur;
- brancher
I'appareil
dans une prise ou un circuit
autre que celui auquel
le r_cepteur
est branch,;
- consulter
un vendeur
ou un technicien
radio/TV
exp_riment_
pour obtenir
de I'aide.
[]_ Playable iPod models
Compatible
iPod:
aaafo
iPod nano (6th generation)
¢
/ *
iPod nano (5th generation)
¢
¢
iPod nano (4th generation)
/
¢
iPod nano (3rd generation)
¢
,/
iPod nano (2nd generation)
¢
-
iPod touch (4th generation)
¢
/
iPod touch (3rd generation)
¢
/
iPod touch (2nd generation)
/
¢
iPod touch
¢
/
iPod classic
¢
¢
iPhone4
¢
¢
iPhone 3GS
¢
¢
iPhone 3G
/
¢
• Only for still picture
• Also refer to the instruction
manual
for iPod.
• If the NOT SUPP indicator
is shown on the display,
the
connected
iPod is not supported.
• If iPod does not play correctly,
update
iPod software
to
the latest version.
For details
about
updating
iPod, check on the Apple
web site <http://www.apple.com/>.
• "Made
for iPod" and "Made for iPhone"
mean that an
electronic
accessory
has been designed
to connect
specifically
to iPod or iPhone,
respectively,
and
has been certified
by the developer
to meet Apple
performance
standards.
Apple
is not responsible
for
the operation
of this device or its compliance
with
safety and regulatory
standards.
Please note that the
use of this accessory
with iPod or iPhone
may affect
wireless
performance.
• iPhone,
iPod, iPod classic, iPod nano and iPod touch
are trademarks
of Apple
Inc., registered
in the U.S.
and other
countries.
HDMI, the HDMI logo and High-Definition
Multimedia
Interface
are trademarks
or registered
trademarks
of
HDMI Licensing
LLC.
HDCP is the abbreviation
of"High-bandwidth
Digital
Content
Protection,"
and is the high-reliable
copy
control
technology
licensed
by Digital
Content
Protection,
LLC.
• In this manual,
"iPod" means iPod, iPod touch
and
iPhone
device.
When iPod touch
or iPhone
device
is especially
referred
to, "iPod touch"
or "iPhone"
is
used.
Advertisement
