Table of Contents
Advertisement
B
A
2. Release the screw (C), which keeps
the burner in position.
C
3. Carefully move the burner off the
injector support (D).
E
4. Slowly move it to the left side. Do not
apply force to the wire of the spark
plug connector (F) and to the
thermocouple conductor (E).
5. Release the burner injector (D) with a
7 mm socket spanner and replace it
with a different one which is
6. Assemble the burner in a reverse
Replace the gas type sticker near the
gas supply ramp with the one related to
the new gas type.
The gas oven burner does not need any
primary gas regulation.
12.4 Minimum level adjustment
of the oven burner
1. Disconnect the appliance from the
2. Turn the knob for the gas control to
3. Adjust the adjustment screw (A) with
D
F
necessary for the type of gas you
use.
Refer to "Technical information"
chapter.
sequence.
Make sure that the gas
supply pressure of the
appliance obeys the
recommended values.
If the supply gas pressure is
changeable or different from
the necessary pressure, you
must fit an applicable
pressure adjuster on the gas
supply pipe.
electricity.
the minimum position and remove it.
a thin-bladed screwdriver.
Change of
the type of
gas
From natural
gas to liquid
gas
ENGLISH
21
A
Adjustment
of the ad‐
justment
screw
Fully tighten
the adjust‐
ment screw
in.
Advertisement
Table of Contents
